set linkflap threshold
Parameters
port‐string
disableInterface
gensyslogentry
gentrap
all
Defaults
If port‐string is not specified, actions will be cleared on all ports.
Mode
Switch mode, read‐write.
Example
This example shows how to clear the link flap violation action on port
Syslog entry.
G3(rw)->clear linkflap action ge.1.4 gensyslogentry
set linkflap threshold
Use this command to set the link flap action trigger count.
Syntax
set linkflap threshold port-string threshold-value
Parameters
port‐string
threshold‐value
Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap threshold on port
G3(rw)->set linkflap threshold ge.1.4 5
set linkflap downtime
Use this command to set the time interval (in seconds) one or more ports will be held down after a
link flap violation.
4-26 Port Configuration
(Optional) Specifies the port(s) on which to clear the link flap action.
Clears the reaction as disabling the interface.
Clears the reaction as generating a syslog entry.
Clears the reaction as generating an SNMP trap.
Clears the reaction as all of the above.
Specifies the port(s) on which to set the link flap action trigger count.
Specifies the number of link down transitions necessary to trigger the
link flap action. A minimum of 1 must be configured.
ge
.1.4 to generating a
ge
.1.4 to 5.