Using the Command Line Interface
Table 1-1 Default Settings for Basic Switch and Router Operation (Continued)
Feature
Split horizon
Stub area (OSPF)
Telnet
Telnet port (IP)
Timers (OSPF)
Transmit delay (OSPF)
VRRP
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
Connect a terminal to the local console port as described in your G‐Series Installation Guide. The
startup screen, Figure
Interface (CLI) by
•
using a default user account, as described in "Using a Default User Account" on page 1‐7, or
•
using an administratively‐assigned user account as described in "Using an Administratively
Configured User Account" on page 1‐7.
Figure 1-1
Username:admin
Password:
Enterasys G-Series
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2006
Chassis Serial Number:
Chassis Firmware Revision:
G3(su)->
1-6 Introduction
Default Setting
Enabled for RIP packets without poison reverse.
None configured.
Enabled.
Set to port number 23.
SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Set to 1 second.
Disabled.
1‐1, will display on the terminal. You can now start the Command Line
G-Series Startup Screen
041800249041
1.00.xx