Set Ipv6 - Enterasys G3G170-24 Cli Reference Manual

set ipv6

Defaults
None.
Mode
Switch mode, read‐only.
Example
This example shows how to display IPv6 management function status.
G3(ro)->show ipv6 status
IPv6 Administrative Mode: Disabled
set ipv6
Use this command to globally enable or disable the IPv6 management function.
Syntax
set ipv6 {enable | disable}
Parameters
enable | disable
Defaults
By default, IPv6 management is disabled.
Mode
Switch mode, read‐write.
Usage
When you enable IPv6 management on the switch, the system automatically generates a link‐local
host address for the switch from the host MAC address. You can set a different host IPv6 address
with the set ipv6 address command.
Example
This example shows how to enable IPv6 management.
G3(su)-> set ipv6 enable
G3(su)->show ipv6 status
IPv6 Administrative Mode: Enabled
G3(su)->show ipv6 address
Name
------------
host
17-2 IPv6 Management
Enable or disable the IPv6 management function.
IPv6 Address
----------------------------------------
FE80::201:F4FF:FE5C:2880/64