Parameters
redundant
non‐redundant
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the system power redundancy mode to non‐redundant:
G3(su)->set system power non-redundant
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Sets the system to operate in redundant power mode. This is the default
setting when two power supplies are installed.
Sets the system to operate in non‐redundant power mode when two
power supplies are installed.
show inlinepower
Enterasys G-Series CLI Reference 2-31