index | all
realm
Mode
Switch command, read‐write.
Defaults
None.
Examples
This example shows how to clear all settings on all RADIUS servers:
G3(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
G3(su)->clear radius timeout
show radius accounting
Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
Parameters
server
counter ip‐address
retries
timeout
Mode
Switch command, read‐only.
Defaults
If no parameters are specified, all RADIUS accounting configuration information will be
displayed.
For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.
(Optional) Displays one or all RADIUS accounting server configurations.
(Optional) Displays counters for a RADIUS accounting server.
(Optional) Displays the maximum number of attempts to contact the
RADIUS accounting server before timing out.
(Optional) Displays the maximum amount of time before timing out.
show radius accounting
Enterasys G-Series CLI Reference 20-7