Passive-Interface; Receive-Interface - Enterasys G3G170-24 Cli Reference Manual

passive-interface

passive-interface
Use this command to prevent RIP from transmitting update packets on an interface. The no form
of this command disables passive interface.
Syntax
passive-interface vlan vlan-id
no passive-interface vlan vlan-id
Parameters
vlan vlan‐id
Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
Usage
This command does not prevent RIP from monitoring updates on the interface.
Example
This example shows how to set VLAN 2 as a passive interface. No RIP updates will be transmitted
on VLAN 2:
G3(su)->router(Config)#router rip
G3(su)->router(Config-router)#passive-interface vlan 2

receive-interface

Use this command to allow RIP to receive update packets on an interface. The no form of this
command denies the reception of RIP updates. By default, receiving is enabled on all routing
interfaces.
Syntax
receive-interface vlan vlan-id
no receive-interface vlan vlan-id
Parameters
vlan vlan‐id
Defaults
None.
16-8 IPv4 Routing Protocol Configuration
Specifies the number of the VLAN to make a passive interface. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 14‐1.
Specifies the number of the VLAN to make a receive interface. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 14‐1.