Show Snmp Persistmode; Set Snmp Persistmode - Enterasys G3G170-24 Cli Reference Manual

show snmp persistmode

For information about...
clear tftp timeout
set tftp retry
clear tftp retry
show snmp persistmode
Use this command to display the configuration persistence mode setting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
By default, the mode is set to "auto save," which automatically saves configuration changes at
specific intervals. If the mode is set to "manual," configuration commands are never automatically
saved. In order to make configuration changes persistent when the mode is manual, the save
config command must be issued as described in "Configuration Persistence Mode" on page 2‐41.
Example
This example shows how to display the configuration persistence mode setting. In this case,
persistence mode is set to "manual", which means configuration changes are not being
automatically saved.
G3(su)->show snmp persistmode
persistmode is manual

set snmp persistmode

Use this command to set the configuration persistence mode, which determines whether user‐
defined configuration changes are saved automatically, or require issuing the save config
command. See "Configuration Persistence Mode" on page 2‐41 for more information.
Syntax
set snmp persistmode {auto | manual}
2-42 Basic Configuration
Refer to page...
2-49
2-49
2-50