Clear Policy Port - Enterasys G3G170-24 Cli Reference Manual

clear policy port

Parameters
port‐string
profile‐index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to allow Gigabit Ethernet ports 5 through 15 in slot 1 to transmit frames
according to policy profile 1:
G3(su)->set policy port ge.1.5-15 1
clear policy port
Use this command to remove a policy profile from one or more ports.
Syntax
clear policy port port-string profile-index
Parameters
port‐string
profile‐index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove policy profile 10 from port 21 in slot 1:
G3(rw)->clear policy port ge.1.21 10
8-14 Policy Classification Configuration
Specifies the port(s) to add to the policy profile. For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐1.
Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile‐index value assigned using the
set policy profile command ("set policy profile" on page 8‐4) in order for
a policy profile to be active on the specified port.
Specifies the port(s) from which to remove the policy profile. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile‐index value assigned using the
set policy profile command ("set policy profile" on page 8‐4) in order for
a policy profile to be active on the specified port.