Example
This example shows how to display the remote system information stored for port
remote system information was received from an IP phone, which is an LLDP‐MED‐enabled
device. Table
3‐5 describes the output fields that are unique to the remote system information
displayed for a MED‐enabled device.
G3(ro)->show lldp port remote-info ge.3.1
Local Port
: ge.3.1
---------------------
Mgmt Addr
: 0.0.0.0
Chassis ID
: 0.0.0.0
Device Type : Communication Device Endpoint (class III)
Sys Name
: AVE0E143D
Sys Cap Supported/Enabled
Auto-Neg Supported/Enabled
Auto-Neg Advertised
Operational Speed/Duplex/Type : 100/full/TX
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer
Model Number
Note that the information fields displayed by the show lldp port remote‐info command will vary,
depending on the type of remote device that is connected to the port.
Table
3‐5 describes the output fields that are unique to the remote system information database.
Refer to Table 3‐4 on page 19 for descriptions of the information fields that are common to both
the local and the remote system information databases.
Table 3-5 show lldp port remote-info Output Display
Output Field
Remote Port Id
Device Type
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer
Model Number
Asset ID
Remote Port Id : 00-09-6e-0e-14-3d
: bridge,telephone/bridge
: yes/yes
: 10BASE-T, 10BASE-TFD
: 100BASE-TX, 100BASE-TXFD
: pause, Spause
: 4610D01A
: b10d01b2_7.bin
: a10d01b2_7.bin
: 05GM42004348
: Avaya
: 4610
What it Displays...
Displays whatever port Id information received in the LLDPDU from the remote
device. In this case, the port Id is MAC address of remote device.
Mandatory LLDP-MED Capabilities TLV. Displayed only when the port is
connected to an LLDP-MED-capable endpoint device.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component. In the above
example, no asset ID was received from the remote device so the field is not
displayed.
show lldp port remote-info
ge
.3.1. The
Enterasys G-Series CLI Reference 3-21