Show Ipv6 Ospf Virtual-Link; Show Ipv6 Ospf Virtual-Link Output Details - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf virtual-link

Table 19-12 show ipv6 ospf stub table Output Details (Continued)
Output Field
Metric Val
Import Summary LSA
show ipv6 ospf virtual-link
This command displays the OSPFv3 virtual interface information for a specific area and neighbor.
Syntax
show ipv6 ospf virtual-link areaid neighborid
Parameters
areaid
neighborid
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Example
This information displays virtual link information for area ID 10 and the neighbor with router ID
of 3.3.3.3.
G3(su)->router(Config)#show ipv6 ospf virtual-link 10 3.3.3.3
Area ID
Neighbor IP Address
Hello Interval
Dead Interval
Iftransit Delay Interval
Retransmit Interval
State
Metric
Neighbor State
Table 19‐13 provides an explanation of the command output.
Table 19-13 show ipv6 ospf virtual-link Output Details
Output Field
Area ID
Neighbor Router ID
Hello Interval
19-44 OSPFv3 Configuration
What It Displays...
The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPFv3 cost for a route is a function of the metric
value.
Controls the import of summary LSAs into stub areas.
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the neighbor by its router ID, specified in 32‐bit dotted quad
format.
What It Displays...
The area id of the requested OSPFv3 area.
The input neighbor Router ID.
The configured hello interval for the OSPFv3 virtual interface.
10
3.3.3.3
10
40
1
5
DOWN
0
DOWN