tunnel mode
tunnel mode
This command specifies the mode of the tunnel interface.
Syntax
tunnel mode ipv6ip
no tunnel mode ipv6ip
Parameters
ipv6ip
Defaults
None.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Tnnl 1))#
Usage
The no form of this command removes the mode of the tunnel.
Example
This example sets the tunnel mode to IPv6 over IPv4.
G3(su)->router(Config)# interface tunnel 1
G3(su)->router(Config-if(Tnnl 1))#
(su)->router(Config-if(Tnnl 1))# tunnel mode ipv6ip
G3
show interface tunnel
This command displays information about a configured tunnel interface.
Syntax
show interface tunnel tunnel-id
Parameters
tunnel‐id
Defaults
None.
Mode
Router global configuration: G3(su)‐>router(Config)#
Router privileged exec: G3(su)‐>router#
Usage
Use this command to display general interface information. Refer to in Chapter 18, IPv6
Configuration for a description of the show ipv6 interface tunnel command.
15-10 IP Configuration
Specifies that the tunnel mode is IPv6 over IPv4
Specifies the tunnel for which to display information.