Clear Policy Rule - Enterasys G3G170-24 Cli Reference Manual

clear policy rule

This example shows how to use Table
source traffic from IP address 1.2.3.4. If mask 32 is not specified as shown, a default mask of 48 bits
(IP address + port) would be applied:
G3(su)->set policy rule 1 ipsourcesocket 1.2.3.4 mask 32 drop
clear policy rule
Use this command to delete policy classification rule entries.
Syntax
clear policy rule profile-index {all-pid-entries | {ether |
ipdestsocket| ipsourcesocket | iptos | macdest | macsource | tcpdestport |
tcpsourceport | udpdestport | udpsourceport}}
Parameters
The following parameters apply to deleting a classification rule.
profile‐index
all‐pid‐entries
ether
icmptype
ipproto
ipdestsocket
ipsourcesocket
iptos
macdest
macsource
tcpdestport
tcpsourceport
udpdestport
udpsourceport
Defaults
When applicable, data and mask must be specified for individual rules to be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to delete Ethernet II Type 1526 classification rule entries associated with
policy profile 1 from all ports
G3(su)->clear policy rule 1 ether 1526
8-12 Policy Classification Configuration
8‐3 to assign a rule to policy profile 1 that will drop IP
Specifies a policy profile for which to delete classification rules. Valid
profile‐index values are 1 ‐ 255.
Deletes all entries associated with the specified policy profile.
Deletes associated Ethernet II classification rule.
Deletes associated ICMP classification rule.
Deletes associated IP protocol classification rule.
Deletes associated IP destination classification rule.
Deletes associated IP source classification rule.
Deletes associated IP Type of Service classification rule.
Deletes associated MAC destination address classification rule.
Deletes associated MAC source address classification rule.
Deletes associated TCP destination port classification rule.
Deletes associated TCP source port classification rule.
Deletes associated UDP destination port classification rule.
Deletes associated UDP source port classification rule.
ipproto|