Show Ipv6 Ospf Range; Show Ipv6 Ospf Neighbor Routerid Output Details - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf range

This example displays the output of this command when a neighbor is specified.
G3(su)->router#show ipv6 ospf neighbor 8.8.8.8
Interface
Area Id
Options
Router Priority
Dead timer due in (secs)
State
Events
Retransmission Queue Length
Table 19‐10 provides an explanation of the command output.
Table 19-10 show ipv6 ospf neighbor routerid Output Details
Output Field
Interface
Area ID
Options
Router Priority
Dead Timer Due
State
Events
Retransmission Queue Length
show ipv6 ospf range
This command displays information about the area ranges for the specified area.
Syntax
show ipv6 ospf range areaid
Parameters
areaid
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
19-42 OSPFv3 Configuration
What It Displays...
Interface of the local router.
OSPFv3 area ID associated with the interface.
An integer value that indicates the optional OSPFv3 capabilities
supported by the neighbor. These are listed in its Hello packets.
This enables received Hello Packets to be rejected (that is,
neighbor relationships will not even start to form) if there is a
mismatch in certain crucial OSPFv3 capabilities.
Router priority for the specified interface.
Amount of time, in seconds, to wait before the router assumes the
neighbor is unreachable.
State of the neighboring routers.
Number of times this neighbor relationship has changed state, or
an error has occurred.
Integer representing the current length of the retransmission
queue of the specified neighbor router Id of the specified interface.
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Vlan 45
0.0.0.30
0x2
128
33
Full/DR
6
0