set inlinepower threshold
Examples
This example shows how to display system power properties. In this case, power redundancy is
set to redundant mode:
G3(su)->show inlinepower
Detection Mode
Total Power Detected
Total Power Available
Total Power Assigned
Power Allocation Mode
Power Trap Status
Power Redundancy Status: redundant
Power Supply 1 Status
Power Supply 2 Status
Slot
----
1
2
3
4
This example shows system power properties when power redundancy is set to non‐redundant
mode:
G3(su)->show inlinepower
Detection Mode
Total Power Detected
Total Power Available
Total Power Assigned
Power Allocation Mode
Power Trap Status
Power Redundancy Status: not redundant
Power Supply 1 Status
Power Supply 2 Status
Slot
----
1
2
3
4
set inlinepower threshold
Use this command to set the power usage threshold on a specified unit or module.
Syntax
set inlinepower threshold usage-threshold unit-number
Parameters
threshold value
module‐number
2-32 Basic Configuration
: auto
: 1200 Watts
: 1000 Watts
: 0 Watts
: auto
: enable
: Ok
: Ok
Status
Power(W)
------
--------
auto
480
auto
480
: auto
: 2400 Watts
: 2200 Watts
: 0 Watts
: auto
: enable
: Ok
: Ok
Status
Power(W)
------
--------
auto
480
auto
480
Specifies a power threshold as a percentage of total system power usage.
Valid values are 11 to 100.
Specifies the module on which to set the power threshold.
Consumption(W)
Usage(%)
--------------
--------
0.00
0.00
0.00
0.00
Consumption(W)
Usage(%)
--------------
--------
0.00
0.00
0.00
0.00
Threshold(%)
Trap
------------
----
80
enable
80
enable
Threshold(%)
Trap
------------
----
80
enable
80
enable