Show Ipv6 Traffic - Enterasys G3G170-24 Cli Reference Manual
G-series
Hide thumbs
Also See for G3G170-24:
- Hardware installation manual (59 pages) ,
- Hardware installation manual (70 pages) ,
- Quick reference (2 pages)
Table of Contents
Advertisement
show ipv6 traffic
Use this command to show traffic and statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [interface]
Parameters
interface
Defaults
If no interface is specified, information about traffic on all interfaces is displayed.
Mode
Router privileged execution: G3(su)‐>router#
Usage
Specify a logical, loopback, or tunnel interface to view information about traffic on a specific
interface. If you do not specify an interface, the command displays information about traffic on all
interfaces.
Example
The following example displays the output of this command.
G3(su)->router>show ipv6 traffic
IPv6 STATISTICS
Total Datagrams Received.................................. 116
Received Datagrams Locally Delivered...................... 116
Received Datagrams Discarded Due To Header Errors......... 0
Received Datagrams Discarded Due To MTU................... 0
Received Datagrams Discarded Due To No Route.............. 0
Received Datagrams With Unknown Protocol.................. 0
Received Datagrams Discarded Due To Invalid Address....... 0
Received Datagrams Discarded Due To Truncated Data........ 0
Received Datagrams Discarded Other........................ 0
Received Datagrams Reassembly Required.................... 0
Datagrams Successfully Reassembled........................ 0
Datagrams Failed To Reassemble............................ 0
Datagrams Forwarded....................................... 0
Datagrams Locally Transmitted............................. 876
Datagrams Transmit Failed................................. 0
Datagrams Successfully Fragmented......................... 0
Datagrams Failed To Fragment.............................. 0
Fragments Created......................................... 0
Multicast Datagrams Received.............................. 17
Multicast Datagrams Transmitted........................... 547
ICMPv6 STATISTICS
(Optional) Specifies the interface for which traffic information should be
displayed. Interface can be of the form:
vlan vlan‐id
tunnel tunnel‐id
loopback loop‐id
show ipv6 traffic
Enterasys G-Series CLI Reference 18-27
Advertisement
Table of Contents
