Table 16-3 show ip ospf database Output Details
Output Field
Link ID
ADV Router
Age
Seq#
Checksum
LinkCount
show ip ospf interface
Use this command to display OSPF interface related information, including network type,
priority, cost, hello interval, and dead interval.
Syntax
show ip ospf interface [vlan vlan-id]
Parameters
vlan vlan‐id
Defaults
If vlan‐id is not specified, OSPF statistics will be displayed for all VLANs.
Mode
Any router mode.
Example
This example shows how to display all OSPF related information for the VLAN 6 interface:
G3(su)->router#show ip ospf interface vlan 6
Vlan 6
Internet Address 192.168.6.2
Router ID 3.3.3.3 , Cost: 10
Transmit Delay is 1 sec , State designated-router , Priority 1
Designated Router id 3.3.3.3 , Interface Addr 192.168.6.2
Backup Designated Router id 2.2.2.2 ,
Timer intervals configured ,
Table
16‐4 provides an explanation of the command output.
What It Displays...
Link ID, which varies as a function of the link state record type, as follows:
• Net Link States - Shows the interface IP address of the designated router to the
broadcast network.
• Router Link States - Shows the ID of the router originating the record.
• Summary Link States - Shows the summary network prefix.
Router ID of the router originating the link state record.
Age (in seconds) of the link state record.
OSPF sequence number assigned to each link state record.
Field in the link state record used to verify the contents upon receipt by another
router.
Link count of router link state records. This number is equal to, or greater than, the
number of active OSPF interfaces on the originating router.
(Optional) Displays OSPF information for a specific VLAN. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 14‐1.
Mask 255.255.255.0, Area 0.0.0.0
(computed)
Hello 10 , Dead 40 , Retransmit 5
show ip ospf interface
Enterasys G-Series CLI Reference 16-27