Show Lacp Output Details - Enterasys G3G170-24 Cli Reference Manual

Defaults
If port‐string is not specified, link aggregation information for all LAGs will be displayed.
Mode
Switch command, read‐only.
Usage
Each G‐Series module provides 6 virtual link aggregator ports, which are designated in the CLI as
lag.0.1 through lag.0.6. Once underlying physical ports (that is,
aggregator port, the resulting aggregation will be represented as one Link Aggregation Group
(LAG) with a lag.x.x port designation.
Example
This example shows how to display lacp information for lag.0.1
output fields.
G3(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs:
Aggregator: lag.0.1
System Identifier:
System Priority:
Admin Key:
Oper Key:
Attached Ports:
Table 4‐6 provides an explanation of the command output.
Table 4-6 show lacp Output Details
Output Field
Global Link
Aggregation state
Single Port LAGs
Aggregator
Actor
Partner
System Identifier
System Priority
Admin Key
disabled
Actor
00:01:F4:5F:1E:20
32768
32768
32768
ge.1.1
ge.1.3
What It Displays...
Shows if LACP is enabled or disabled on the switch.
Displays if the single port LAG feature has been enabled on the switch. See
singleportlag" on page 4-41 for more about single port LAG.
LAG port designation. Each G-Series module provides 6 virtual link aggregator ports,
which are designated in the CLI as lag.0.1 through lag.0.6. Once underlying physical
ports (for example, ge.x.x) are associated with an aggregator port, the resulting Link
Aggregation Group (LAG) is represented with a lag.x.x port designation.
Local device participating in LACP negotiation.
Remote device participating in LACP negotiation.
MAC addresses for actor and partner.
System priority value which determines aggregation precedence. Only one LACP
system priority can be set on a G-Series device, using either the set lacp asyspri
command (page 4-38), or the set port lacp command
Port's assigned key. G-Series devices provide a default admin key value of 32768 for
all LAG ports (lag.0.1 though lag.0.6).
ge
.x.x) are associated with an
.
The following table describes the
Partner
00:11:88:11:74:F9
32768
0
(page 4-44)
Enterasys G-Series CLI Reference 4-37
show lacp
"set lacp
.