Set Sntp Server; Clear Sntp Server - Enterasys G3G170-24 Cli Reference Manual

set sntp server

set sntp server
Use this command to add a server from which the SNTP client will retrieve the current time when
operating in unicast mode. Up to 10 servers can be set as SNTP servers.
Syntax
set sntp server ip-address [precedence]
Parameters
ip‐address
precedence
Defaults
If precedence is not specified, 1 will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to set the server at IP address 10.21.1.100 as an SNTP server:
G3(su)->set sntp server 10.21.1.100

clear sntp server

Use this command to remove one or all servers from the SNTP server list.
Syntax
clear sntp server {ip-address | all}
Parameters
ip‐address
all
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove the server at IP address 10.21.1.100 from the SNTP server list:
G3(su)->clear sntp server 10.21.1.100
11-28 Logging and Network Management
Specifies the SNTP server's IP address.
(Optional) Specifies this SNTP server's precedence in relation to its peers.
Valid values are 1 (highest) to 10 (lowest).
Specifies the IP address of a server to remove from the SNTP server list.
Removes all servers from the SNTP server list.