Usage
Refer to RFC 2461, "Neighbor Discovery for IP Version 6," for more information about router
advertisements.
Router advertisements contain a list of prefixes used for on‐link determination and/or
autonomous address configuration. Flags associated with the prefixes specify the intended uses of
a particular prefix. Hosts use the advertised on‐link prefixes to build and maintain a list that is
used in deciding when a packet's destination is on‐link or beyond a router. Hosts can use the
advertised autoconfiguration prefixes to perform autonomous (stateless) address configuration, if
stateless configuration is allowed (see ipv6 nd other‐config‐flag).
The no form of this command removes the prefix from the list of prefixes advertised in router
advertisements by this interface.
Example
This example configures a prefix that can be used for both on‐link determination and
autoconfiguration, using the default values for valid lifetime and preferred lifetime.
G3
(su)->router(Config-if(Vlan 1))# ipv6 nd prefix 2001:0db8:4444:5555/64
Query Commands
For information about...
show ipv6
show ipv6 interface
show ipv6 neighbors
show ipv6 route
show ipv6 route preferences
show ipv6 route summary
show ipv6 traffic
clear ipv6 statistics
show ipv6
This command displays the status of IPv6 forwarding mode and unicast routing mode.
Syntax
show ipv6
Parameters
None.
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Query Commands
Refer to page...
18-19
18-20
18-21
18-22
18-24
18-26
18-27
18-32
Enterasys G-Series CLI Reference 18-19