Configuring Snmp Target Parameters; Purpose; Commands; Show Snmp Targetparams - Enterasys G3G170-24 Cli Reference Manual

Configuring SNMP Target Parameters

Configuring SNMP Target Parameters

Purpose

To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command ("set snmp targetaddr" on page 5‐26).

Commands

For information about...

show snmp targetparams

set snmp targetparams
clear snmp targetparams
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
targetParams
volatile | nonvolatile |
read‐only
Defaults
If targetParams is not specified, entries associated with all target parameters will be displayed.
If not specified, entries of all storage types will be displayed.
Mode
Switch command, read‐only.
5-22 SNMP Configuration
(Optional) Displays entries for a specific target parameter.
(Optional) Displays target parameter entries for a specific storage
type.
Refer to page...
5-22
5-23
5-24