Set Port Lacp - Enterasys G3G170-24 Cli Reference Manual

set port lacp

MarkerPDUsTx:
MarkerResponsePDUsRx:
MarkerResponsePDUsTx:
set port lacp
Use this command to set link aggregation parameters for one or more ports. These settings will
determine the specified underlying physical ports' ability to join a LAG, and their administrative
state once aggregated.
Syntax
set port lacp port port-string {[aadminkey aadminkey] [aadminstate {lacpactive |
lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef | lacpexpire}]
[aportpri aportpri] [asyspri asyspri] [enable | [disable] [padminkey padminkey]
[padminport padminport] [padminportpri padminportpri] [padminstate {lacpactive |
lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef | lacpexpire}]
[padminsysid padminsysid] [padminsyspri padminsyspri]
Parameters
port port‐string
aadminkey
aadminkey
aadminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire
aportpri aportpri
asyspri asyspri
enable
4-44 Port Configuration
374
Specifies the physical port(s) on which to configure LACP. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Sets the port's actor admin key. LACP will use this value to form an oper
key and will determine which underlying physical ports are capable of
aggregating by comparing oper keys. Aggregator ports allow only
underlying ports with oper keys matching theirs to join their LAG. Valid
values are 1 ‐ 65535. The default key value is 32768.
Sets the port's actor LACP administrative state to allow for:
lacpactive ‐ Transmitting LACP PDUs.
lacptimeout ‐ Transmitting LACP PDUs every 1 sec. vs 30 sec. (default).
lacpagg ‐ Aggregation on this port.
lacpsync ‐ Transition to synchronization state.
lacpcollect ‐ Transition to collection state.
lacpdist ‐ Transition to distribution state.
lacpdef ‐ Transition to defaulted state.
lacpexpire ‐ Transition to expired state.
Sets the port's actor port priority. Valid values are 0 ‐ 65535, with lower
values designating higher priority.
Sets the port's actor system priority. The LACP implementation on the G‐
Series device uses this value to determine aggregation precedence when
there are two devices competing for the same aggregator. Valid values are
0 ‐ 65535, with higher precedence given to lower values.
Note: Only one LACP system priority can be set on a G-Series
device, using either this command, or the set lacp asyspri command
("set lacp asyspri" on page 4-38).
(Optional) Enables LACPDU processing on this port.
0
0