Mode
Switch command, read‐write.
Usage
Use this command to create and configure Layer 2 IGMP entries.
Example
This example creates an IGMP entry for the multicast group with IP address of 233.11.22.33
configured on VLAN 20 configured with the port
G3(su)->set igmpsnooping add-static 233.11.22.33 20 ge.1.1
set igmpsnooping remove-static
This command deletes a static IGMP entry or removes one or more new ports from an existing
entry.
Syntax
set igmpsnooping remove-static group vlan-list [modify] [port-string]
Parameters
group
vlan‐list
modify
port‐string
Defaults
If no ports are specified, all ports are removed from the entry.
Mode
Switch command, read‐write.
Example
This example removes port
233.11.22.33 configured on VLAN 20.
G3(su)->set igmpsnooping remove-static 233.11.22.33 20 ge.1.1
show igmpsnooping static
This command displays static IGMP ports for one or more VLANs or IGMP groups.
Syntax
show igmpsnooping static vlan-list [group group]
Parameters
vlan‐list
Specifies the multicast group IP address of the entry.
Specifies the VLANs on which the entry is configured.
(Optional) Removes the specified port or ports from an existing entry.
(Optional) Specifies the port or ports to remove from the entry.
ge
.1.1 from the entry for the multicast group with IP address of
Specifies the VLAN for which to display static IGMP ports.
set igmpsnooping remove-static
ge
.1.1.
Enterasys G-Series CLI Reference 10-7