Clear Lldp; Clear Lldp Port Status - Enterasys G3G170-24 Cli Reference Manual

clear lldp

clear lldp
Use this command to return LLDP parameters to their default values.
Syntax
clear lldp {all | tx-interval | hold-multiplier | trap-interval | med-fast-repeat}
Parameters
all
tx‐interval
hold‐multiplier
trap‐interval
med‐fast‐repeat
Defaults
None.
Mode
Switch command, read‐write.
Example
This example returns the transmit interval to the default value of 30 seconds.
G3(rw)->clear lldp tx-interval

clear lldp port status

Use this command to return the port status to the default value of both (both transmitting and
processing received LLDPDUs are enabled).
Syntax
clear lldp port status port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
3-28 Discovery Protocol Configuration
Returns all LLDP configuration parameters to their default values,
including port LLDP configuration parameters.
Returns the number of seconds between transmissions of LLDP
frames.to the default of 30 seconds.
Returns the multiplier to apply to the transmit interval to determine
the time‐to‐live value to the default value of 4.
Returns the minimum time between LLSP trap transmissions to the
default value of 5 seconds.
Returns the number of fast start LLDPDUs to be sent when an LLDP‐
MED endpoint device is detected to the default of 3.
Specifies the port or range of ports to be affected.