set lldp port tx-tlv
Parameters
elin
elin‐string
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
After you configure a location information value, you must also configure the port to send the
Location Information TLV with the set lldp port tx‐tlv command. This example configures the
ELIN identifier 5551234567 on ports
the Location Information TLV.
G3(rw)->set lldp port location-info 5551234567 ge.1.1-6
G3(rw)->set lldp port tx-tlv med-loc ge.1.1-6
set lldp port tx-tlv
Use this command to select the optional LLDP and LLDP‐MED TLVs to be transmitted in
LLDPDUs by the specified port or ports. Use the show lldp port local‐info command to display
the values of these TLVs for the port.
Syntax
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-loc] [med-poe]} port-string
Parameters
all
port‐desc
sys‐name
sys‐desc
sys‐cap
mgmt‐addr
vlan‐id
3-26 Discovery Protocol Configuration
Specifies that the ECS ELIN data format is to be used.
Specifies the location identifier. Value can be from 10 to 25 numerical
characters.
Specifies the port or range of ports to be affected.
ge
.1.1 through
Adds all optional TLVs to transmitted LLDPDUs.
Port Description optional basic LLDP TLV. Value sent is ifDescr
object defined in RFC 2863.
System Name optional basic LLDP TLV. Value sent is the
administratively assigned name for the system.
System Description optional basic LLDP TLV. Value sent is sysDescr
object defined in RFC 3418.
System Capabilities optional basic LLDP TLV. For a network
connectivity device, value sent can be bridge and/or router.
Management Address optional basic LLDP TLV. Value sent is IPv4
address of host interface.
Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is port VLAN
ID (PVID).
ge
.1.6 and then configures the ports to send