Show Pwa; Show Pwa Output Details - Enterasys G3G170-24 Cli Reference Manual

show pwa

show pwa
Use this command to display port web authentication information for one or more ports.
Syntax
show pwa [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, PWA information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display PWA information for
G3(su)->show pwa ge.2.1
PWA Status
PWA IP Address
PWA Protocol
PWA Enhanced Mode
PWA Logo
PWA Guest Networking Status - disabled
PWA Guest Name
PWA Redirect Time
Port
-------- ----------------
ge.2.1
Table 20‐8 provides an explanation of the command output.
Table 20-8 show pwa Output Details
Output Field
PWA Status
PWA IP Address
PWA Protocol
PWA Enhanced
Mode
20-58 Security Configuration
(Optional) Displays PWA information for specific port(s).
- enabled
- 192.168.62.99
- PAP
- N/A
- enabled
- guest
- N/A
Mode AuthStatus
--------------
disabled disconnected
What It Displays...
Whether or not port web authentication is enabled or disabled. Default state of
disabled can be changed using the set pwa command as described in
page 20-59.
IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
"set pwa ipaddress" on page 20-62.
Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the set pwa protocol command as described in
page 20-62.
Whether PWA enhanced mode is enabled or disabled. Default state of disabled can
be changed using the
enhancedmode" on page 20-68.
ge .2.1:
QuietPeriod
-----------
60
set pwa enhancedmode command as described in
MaxReq
---------
16
"set pwa" on
"set pwa protocol" on
"set pwa