show ip vrrp
Use this command to display VRRP routing information.
Syntax
show ip vrrp
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display VRRP information
G3(su)->router(Config)#show ip vrrp
-----------VRRP CONFIGURATION-----------
Vlan
2
Configuring PIM-SM
PIM is an advanced routing feature that must be enabled with a license key. If you have purchased an
advanced license key, and have enabled routing on the device, you must activate your license as described
in
"Activating Licensed
purchase an advanced routing license, contact Enterasys Networks Sales.
Purpose
To enable and configure Protocol Independent Multicast in Sparse Mode (PIM‐SM). This protocol
provides the means of dynamically learning how to forward multicast traffic in an environment
where group members are sparsely located throughout the network and bandwidth is limited. In
situations where members are densely located and bandwidth is plentiful, DVMRP would suffice
(see "Configuring DVMRP" on page 16‐31.)
PIM‐SM determines the network topology using the underlying unicast routing protocol to build
a Multicast Routing Information Base (MRIB).
Vrid
State
Owner
1
Initialize
* Advanced License Required *
Features" on page 2-27.in order to enable the PIM command set. If you wish to
Note: IGMP must be enabled on all VLANs running PIM-SM, and must also be globally enabled
on the G-Series. For details on enabling IGMP, refer to
AssocIpAddr
Priority
0
25.25.2.1
100
Chapter
10.
Enterasys G-Series CLI Reference 16-45
show ip vrrp