Router Id - Enterasys G3G170-24 Cli Reference Manual

Table 16-2 OSPF Configuration Task List and Commands (Continued)
To do this...
• Configure OSPF authentication.
Configure OSPF Areas.
• Configure an administrative distance.
• Define the range of addresses to be used
by Area Boundary Routers (ABRs).
• Define an area as a stub area.
• Set the cost value for the default route that
is sent into a stub area.
• Define an area as an NSSA.
Create virtual links.
Enable redistribution from non-OSPF
routes.
Monitor and maintain OSPF.

router id

Use this command to set the OSPF router ID for the device. This IP address must be set manually
in order to run OSPF. The no form of this command removes the router ID for the device.
Syntax
router id ip-address
no router id
Parameters
ip‐address
Defaults
None.
Mode
Global configuration: G3(su)‐>router(Config)#
Specifies the IP address that OSPF will use as the router ID.
Use these commands...
"ip ospf authentication-key" on page 16-18
"ip ospf message digest key
"distance ospf" on page 16-19
"area range" on page 16-20
"area stub" on page 16-21
"area default cost" on page 16-21
"area nssa" on page 16-22
"area virtual-link" on page 16-23
"redistribute" on page 16-24
"show ip ospf" on page 16-25
"show ip ospf neighbor" on page 16-28
"show ip ospf interface" on page 16-27
"show ip ospf neighbor" on page 16-28
"show ip ospf virtual-links" on page 16-29
"clear ip ospf process" on page 16-30
Enterasys G-Series CLI Reference 16-11
router id
md5" on page 16-18