Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
Example
This example shows how to enable RFC 1583 compatibility:
G3(su)->router(Config)#router ospf 1
G3(su)->router(Config-router)#1583compatability
ip ospf enable
Use this command to enable OSPF on an interface. The no form of this command disables OSPF on
an interface.
Syntax
ip ospf enable
no ip ospf enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: G3
Example
This example shows how to enable OSPF on the VLAN 1 interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip ospf enable
ip ospf areaid
Use this command to configure area IDs for OSPF interfaces. If OSPF is enabled on an interface as
described in "ip ospf enable" on page 16‐13, the OSPF area will default to 0.0.0.0. The no form of
this command removes OSPF routing for the interfaces.
Syntax
ip ospf areaid area-id
no ip ospf areaid
Parameters
area‐id
(su)‐>router(Config‐if(Vlan 1))#
Specifies the area‐id to be associated with the OSPF interface. Valid values
are decimal values or IP addresses.
ip ospf enable
Enterasys G-Series CLI Reference 16-13