clear spantree spanguard
clear spantree spanguard
Use this command to reset the status of the Spanning Tree SpanGuard function to disabled.
Syntax
clear spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the status of the SpanGuard function to disabled:
G3(rw)->clear spantree spanguard
show spantree spanguardtimeout
Use this command to display the Spanning Tree SpanGuard timeout setting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard timeout setting:
G3(su)->show spantree spanguardtimeout
Spanguard timeout: 300
set spantree spanguardtimeout
Use this command to set the amount of time (in seconds) an edge port will remain locked by the
SpanGuard function.
6-26 Spanning Tree Configuration