Enabling / Disabling Jumbo Frame Support; Purpose; Commands; Show Port Jumbo - Enterasys G3G170-24 Cli Reference Manual

Enabling / Disabling Jumbo Frame Support

Parameters
port‐string
full | half
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set ge.1.17 to full duplex:
G3(su)->set port duplex ge.1.17 full
Enabling / Disabling Jumbo Frame Support

Purpose

To review, enable, and disable jumbo frame support on one or more ports. This allows Gigabit
Ethernet ports to transmit frames up to 10 KB in size.

Commands

For information about...

show port jumbo

set port jumbo
clear port jumbo
show port jumbo
Use this command to display the status of jumbo frame support and maximum transmission units
(MTU) on one or more ports.
Syntax
show port jumbo [port-string]
Parameters
port‐string
4-12 Port Configuration
Specifies the port(s) for which duplex type will be set. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐1.
Sets the port(s) to full‐duplex or half‐duplex operation.
(Optional) Displays the status of jumbo frame support for specific
port(s). For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 4‐1.
Refer to page...
4-12
4-13
4-13