clear cos reference
Parameters
irl
group‐type‐index
Defaults
If irl is not specified, all CoS reference information is displayed.
If a specific port group is not specified, information for all port groups is displayed.
Mode
Switch command, read‐only.
Example
This example shows the Class of Service IRL references for port group 1.0. Note that not all of the
100 possible references are displayed in this output example.
G3(su)->show cos reference irl 1.0
Group Index Reference Type Rate Limiter
----------- --------- ---- ------------
1.0
1.0
1.0
1.0
...
1.0
1.0
1.0
clear cos reference
Use this command to clear the Class of Service inbound rate limiting reference configuration.
Syntax
clear cos reference irl {all | group-type-index reference}
Parameters
irl
all
group‐type‐index
8-28 Policy Classification Configuration
(Optional) Specifies that inbound rate limiting reference information
should be displayed.
(Optional) Specifies an inbound rate limiting port group/type index.
Valid entries are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
0
irl
none
1
irl
1
2
irl
none
3
irl
none
97
irl
none
98
irl
none
99
irl
none
Specifies that IRL references are being cleared.
Clear all groups indexes and references.
Specifies an inbound rate limiting port group/type index. Valid entries
are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.