Ipv6 Enable - Enterasys G3G170-24 Cli Reference Manual

ipv6 enable

Usage
Use this command to manually configure a global IPv6 address on an interface. You can enter the
complete 128‐bit address and prefix, or use the eui64 parameter to configure a global IPv6 address
using an EUI‐64 identifier in the low order 64 bits of the address. When using the eui64 parameter,
you specify only the network prefix and length, and the Enterasys G‐Series generates the low
order 64 bits.
The hexadecimal letters in the IPv6 addresses are not case‐sensitive.
This command also enables IPv6 processing on the interface and automatically generates a link‐
local address.
You can assign multiple globally reachable addresses to an interface with this command.
Use the no ipv6 address command without any parameters to remove all manually configured
IPv6 addresses from the interface.
Example
This example configures an IPv6 address by using the eui64 parameter. Then, the show ipv6
interface is executed to display the configuration. Note that a link‐local address has also
automatically been generated.
G3(su)->router(Config-if(Vlan 7))# ipv6 address 3FFE:501:FFFF:101/64 eui64
G3(su)->router>show ipv6 interface vlan 7
Vlan 7 Administrative Mode
Vlan 7 IPv6 Routing Operational Mode
IPv6 is
IPv6 Prefix is
Routing Mode
Interface Maximum Transmit Unit
Router Duplicate Address Detection Transmits
Router Advertisement NS Interval
Router Lifetime Interval
Router Advertisement Reachable Time
Router Advertisement Interval
Router Advertisement Managed Config Flag
Router Advertisement Other Config Flag
Router Advertisement Suppress Flag
ipv6 enable
This command enables IPv6 routing on an interface that has not been configured with an explicit
IPv6 address.
Syntax
ipv6 enable
no ipv6 enable
Parameters
None.
Defaults
IPv6 is disabled.
18-10 IPv6 Configuration
Enabled
Enabled
Enabled
FE80::211:88FF:FE55:4A7F/128
3FFE:501:FFFF:101:211:88FF:FE55:4A7F/64
Enabled
1500
1
0
1800
0
600
Disabled
Disabled
Disabled