Telnet - Enterasys G3G170-24 Cli Reference Manual

Hide thumbs Also See for G3G170-24:

Table of Contents

telnet

enable | disable

outbound | all

If not specified, both inbound and outbound Telnet service will be enabled.

Switch command, read‐write.

This example shows how to disable inbound and outbound Telnet services:

G3(su)->set telnet disable all

Disconnect all telnet sessions and disable now (y/n)? [n]: y

All telnet sessions have been terminated, telnet is now disabled.

Use this command to start a Telnet connection to a remote host. The G‐Series switch allows a total

of four inbound and / or outbound Telnet session to run simultaneously.

telnet host [port]

If not specified, the default port number 23 will be used.

Switch command, read‐write.

This example shows how to start a Telnet session to a host at 10.21.42.13:

G3(su)->telnet 10.21.42.13

2-40 Basic Configuration

Enables or disables Telnet services.

(Optional) Specifies inbound service (the ability to Telnet to this switch),

outbound service (the ability to Telnet to other devices), or all (both

inbound and outbound).

Specifies the name or IP address of the remote host.

(Optional) Specifies the server port number.