Global Ospfv3 Configuration Commands; Purpose; Command; Ipv6 Router Id - Enterasys G3G170-24 Cli Reference Manual

Global OSPFv3 Configuration Commands

Purpose

These commands are used to configure a router ID for the OSPFv3 router, to enter router OSPFv3
configuration mode, and to configure global OSPFv3 parameters.

Command

For information about...

ipv6 router id

ipv6 router ospf
default-information originate
default-metric
distance ospf
exit-overflow-interval
external-lsdb-limit
maximum-paths
redistribute
ipv6 router id
This command configures a 32‐bit integer, entered in 32‐bit dotted‐quad notation, used to
uniquely identify this OSPFv3 router.
Syntax
ipv6 router id ip-address
Parameters
ip‐address
Defaults
None.
Mode
Router global configuration: G3(su)‐>router(Config)#
Usage
Use this command to configure the OSPFv3 router ID.
Example
This example illustrates configuring the OSPFv3 router ID as 2.2.2.2.
G3(su)->router(Config)# ipv6 router id 2.2.2.2
Specifies the ID of the OSPFv3 router, in 32‐bit dotted‐quad notation.
Global OSPFv3 Configuration Commands
Refer to page...
19-3
19-4
19-4
19-5
19-5
19-6
19-7
19-8
19-8
Enterasys G-Series CLI Reference 19-3