Clear Spantree Mstmap - Enterasys G3G170-24 Cli Reference Manual

clear spantree mstmap

Syntax
set spantree mstmap fid [sid sid]
Parameters
fid
sid sid
Defaults
If sid is not specified, FID(s) will be mapped to Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to map FID 3 to SID 2:
G3(su)->set spantree mstmap 3 sid 2
clear spantree mstmap
Use this command to map a FID back to SID 0.
Syntax
clear spantree mstmap fid
Parameters
fid
Defaults
If fid is not specified, all SID to FID mappings will be reset.
Mode
Switch command, read‐write.
Example
This example shows how to map FID 2 back to SID 0:
G3(su)->clear spantree mstmap 2
6-14 Spanning Tree Configuration
Note: Since any MST maps that are associated with GVRP-generated VLANs will be removed from
the configuration if GVRP communication is lost, it is recommended that you only create MST maps
on statically-created VLANs.
Specifies one or more FIDs to assign to the MST. Valid values are 1 ‐ 4093,
and must correspond to a VLAN ID created using the set vlan command.
(Optional) Specifies a Multiple Spanning Tree ID. Valid values are 1 ‐ 4094,
and must correspond to a SID created using the set msti command.
Specifies one or more FIDs to reset to 0.