Set Rmon Filter - Enterasys G3G170-24 Cli Reference Manual

set rmon filter

Parameters
index index |
channel channel
Defaults
If no options are specified, information for all filter entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display all RMON filter entries and channel information:
G3(rw)->show rmon filter
Index= 55508
----------------------------------------------------------
Data Offset
PktStatusMask
Owner
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00
set rmon filter
Use this command to configure an RMON filter entry.
Syntax
set rmon filter index channel-index [offset offset] [status status] [smask smask]
[snotmask snotmask] [data data] [dmask dmask] [dnotmask dnotmask] [owner owner]
Parameters
index
channel‐index
offset offset
status status
smask smask
snotmask snotmask
data data
12-18 RMON Configuration
(Optional) Displays information about a specific filter entry, or about all
filters which belong to a specific channel.
Channel Index= 628
0 PktStatus
0 PktStatusNotMask
ETS,NAC-D
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 10. Maximum value is 65535.
Specifies the channel to which this filter will be applied.
(Optional) Specifies an offset from the beginning of the packet to look for
matches.
(Optional) Specifies packet status bits that are to be matched.
(Optional) Specifies the mask applied to status to indicate which bits are
significant.
(Optional) Specifies the inversion mask that indicates which bits should
be set or not set
(Optional) Specifies the data to be matched.
EntryStatus= valid
0
0