Table 4-3 show linkflap parameters Output Details
Output Field
Port
LF Status
Actions
Threshold
Interval
Downtime
This example shows how to display the link flap metrics table:
G3(rw)->show linkflap metrics
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table
4‐4 provides an explanation of the show linkflap metrics command output.
Table 4-4 show linkflap metrics Output Details
Output Field
Port
LinkStatus
CurrentCount
TotalCount
TimeElapsed
Violations
set linkflap globalstate
Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
disable | enable
Defaults
By default, the function is disabled globally and on all ports.
LinkStatus
CurrentCount
-----------
------------
operational
0
disabled
4
operational
3
Globally disables or enables the link flap detection function.
What it displays...
Port designation.
Link flap enabled state.
Actions to be taken if the port violates allowed link flap behavior.
D = disabled, S = Syslog entry will be generated, T= SNMP trap
will be generated.
Number of link down transitions necessary to trigger the link flap
action.
Time interval (in seconds) for accumulating link down transitions.
Interval (in seconds) port(s) will be held down after a link flap
violation.
TotalCount
TimeElapsed
----------
----------- -------------
0
241437
15
147
3
241402
What it displays...
Port designation.
Link status according to the link flap function.
Link down count accruing toward the link flap threshold.
Number of link downs since system start,
Time (in seconds) since the last link down event.
Number of link flap violations on listed ports since system start.
set linkflap globalstate
Violations
0
5
0
Enterasys G-Series CLI Reference 4-23