Show Ipv6 Ospf Interface Stats - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf interface stats

Table 19-7 show ipv6 ospf interface Command Output Details (Continued)
Output Field
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
Authentication Type
Metric Cost
OSPF MTU-ignore
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
show ipv6 ospf interface stats
This command displays statistics for a specific interface. Statistics are displayed only if OSPFv3 is
enabled.
Syntax
show ipv6 ospf interface stats vlan vlanid
Parameters
vlan vlanid
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
19-38 OSPFv3 Configuration
What It Displays...
The frequency, in seconds, at which the interface sends LSA.
The frequency, in seconds, at which the interface sends Hello
packets.
The amount of time, in seconds, the interface waits before
assuming a neighbor is down.
The amount of time, in seconds, the interface waits before
sending an LSA acknowledgement after receiving an LSA.
The number of seconds the interface adds to the age of LSA
packets before transmission.
The type of authentication the interface performs on LSAs it
receives.
The priority of the path. Low costs have a higher priority than high
costs.
Whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers. The following information
only displays if OSPF is initialized on the interface:
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. Tunnel interfaces take the value point-to-point.
The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router.
The router ID representing the designated router.
The router ID representing the backup designated router.
The number of link events.
Specifies the VLAN interface for which to display statistics.