Show Cos State; Clear Cos State - Enterasys G3G170-24 Cli Reference Manual

show cos state

Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable Class of Service:
G3(rw)->set cos state enable
show cos state
Use this command to display the Class of Service enable state.
Syntax
show cos state
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to show the Class of Service enable state:
G3(rw)->show cos state
Class-of-Service application is enabled

clear cos state

Use this command to set CoS state back to its default setting of disabled.
Syntax
clear cos state
Parameters
None.
8-18 Policy Classification Configuration
Enables or disables Class of Service on the switch. Default state is
disabled.