Show Ipv6 Ospf Abr; Show Ipv6 Ospf Area Output Details - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf abr

Table 19-2 show ipv6 ospf area Output Details
Output Field
AreaID
External Routing
Spf Runs
Area Border Router Count
Area LSA Count
Area LSA Checksum
Stub Mode
Import Summary LSAs
OSPF Stub Metric Value
show ipv6 ospf abr
This command displays OSPFv3 routes to reach area border routers.
Syntax
show ipv6 ospf abr
Parameters
None.
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Example
This example shows how to display OSPFv3 area border router information.
G3(su)->router# show ipv6 ospf abr
Type
----- -------------- ---- ------------ -------------------------------- --------
INTRA 82.15.0.1
Table 19‐3 provides an explanation of the command output.
19-30 OSPFv3 Configuration
Router Id Cost
10 0.0.0.10
What It Displays...
Area ID of the requested OSPFv3 area.
The external routing capabilities for this area.
Number of times that the intra-area route table has been
calculated using this area's link-state database.
Total number of area border routers reachable within this area.
Total number of link-state advertisements in this area's link-state
database, excluding AS External LSAs.
Number representing the Area LSA Checksum for the specified
Area ID excluding the external (LS type 5) link-state
advertisements.
Whether the specified area is a stub area or not. The possible
values are enabled and disabled. This is a configured value.
Whether to import summary LSAs (enabled or disabled).
Metric value of the stub area. This field displays only if the area is
a configured as a stub area.
Area ID
FE80::200:2DFF:FEE6:FB6B
Next Hop Next Hop
Intf
Vlan 48