Set Cdp Interval - Enterasys G3G170-24 Cli Reference Manual

set cdp interval

Parameters
auth‐code
Defaults
None.
Mode
Switch command, read‐write.
Usage
The authentication code value determines a switch's CDP domain. If two or more switches have
the same CDP authentication code, they will be entered into each other's CDP neighbor tables. If
they have different authentication codes, they are in different domains and will not be entered
into each other's CDP neighbor tables.
A switch with the default authentication code (16 null characters) will recognize all switches, no
matter what their authentication code, and enter them into its CDP neighbor table.
Example
This example shows how to set the CDP authentication code to 1,2,3,4,5,6,7,8:
G3(su)->set cdp auth 1,2,3,4,5,6,7,8:
set cdp interval
Use this command to set the message interval frequency (in seconds) of the CDP discovery
protocol.
Syntax
set cdp interval frequency
Parameters
frequency
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the CDP interval frequency to 15 seconds:
G3(su)->set cdp interval 15
3-4 Discovery Protocol Configuration
Specifies an authentication code for the CDP protocol. This can be up to 16
hexadecimal values separated by commas.
Specifies the transmit frequency of CDP messages in seconds.Valid values
are from 5 to 900 seconds.