Show Dhcp Conflict; Clear Dhcp Conflict - Enterasys G3G170-24 Cli Reference Manual

show dhcp conflict

Use this command to display conflict information, for one address or all addresses.
Syntax
show dhcp conflict [address]
Parameters
address
Defaults
If no address is specified, conflict information for all addresses is displayed.
Mode
Read‐only.
Example
This example displays conflict information for all addresses. Note that ping is the only detection
method used.
G3(ro)->show dhcp conflict
IP address
-----------
192.0.0.2
192.0.0.3
192.0.0.4
192.0.0.12

clear dhcp conflict

Use this command to clear conflict information for one or all addresses, or to disable conflict
logging.
Syntax
clear dhcp conflict {logging | ip-address| *}
Parameters
logging
ip‐address
*
Defaults
None.
Mode
Switch command, read‐write.
[Optional] Specifies the address for which to display conflict information.
Detection Method
-----------------
Ping
Ping
Ping
Ping
Disables conflict logging.
Clears the conflict information for the specified IP address.
Clears the conflict information for all IP addresses.
Detection Time
---------------
0 days 19h:01m:23s
0 days 19h:00m:46s
0 days 19h:01m:25s
0 days 19h:01m:26s
Enterasys G-Series CLI Reference 13-5
show dhcp conflict