Clear Lacp Static; Set Lacp Singleportlag - Enterasys G3G170-24 Cli Reference Manual

clear lacp static

Use this command to remove specific ports from a Link Aggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
lagportstring
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove
G3(su)->clear lacp static lag.0.6 ge.1.6

set lacp singleportlag

Use this command to enable or disable the formation of single port LAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Usage
When single port LAGs are enabled, Link Aggregration Groups can be formed when only one
port is receiving protocol transmissions from a partner. When this setting is disabled, two or more
ports are required to form a LAG.
This setting has no effect on existing LAGs created with multiple member ports. It also does not
prevent previously formed LAGs from coming up after they have gone down, as long as any
Specifies the LAG aggregator port from which ports will be removed.
Specifies the port(s) to remove from the LAG. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐1.
ge .1.6 from the LAG of aggregator port 6:
Enables or disables the formation of single port LAGs.
clear lacp static
Enterasys G-Series CLI Reference 4-41