Default-Metric; Distance Ospf - Enterasys G3G170-24 Cli Reference Manual

Mode
Router OSPFv3 configuration: G3(su)‐>router(Config‐router)#
Usage
Use this command to generate a default external route into an OSPFv3 routing domain. Use the no
form of this command to stop the generation of a default external route.
Example
This example specifies a metric of 100 for the default route redistributed into the OSPFv3 routing
domain, and an external metric type of 1.
G3(su)->router(Config-router)# default-information originate metric 100
metric-type 1

default-metric

This command sets a default metric for routes redistributed from another protocol into OSPFv3.
Syntax
default-metric metric
no default-metric
Parameters
metric
Defaults
No default metric is configured.
Mode
Router OSPFv3 configuration: G3
Usage
Use this command to cause the same metric value to be used for all redistributed routes.
Use the no form of this command to remove a configured default metric.
Example
This example configures a metric of 100 to be used for all redistributed routes.
G3(su)->router(Config-router)# default-metric 100

distance ospf

This command sets the route preference value of OSPFv3.
Syntax
distance ospf {intra | inter | type1 | type2} preference
no distance ospf {intra | inter | type1 | type2}
The value of metric can range from 1 to 16777214.
(su)->router(Config-router)#
default-metric
Enterasys G-Series CLI Reference 19-5