For information about...
set multiauth idle-timeout
clear multiauth idle-timeout
show multiauth session-timeout
set multiauth session-timeout
clear multiauth session-timeout
show multiauth
Use this command to display multiple authentication system configuration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display multiple authentication system configuration:
G3(rw)->show multiauth
Multiple authentication system configuration
-------------------------------------------------
Supported types
Maximum number of users
Current number of users
System mode
Default precedence
Admin precedence
Operational precedence
set multiauth mode
Use this command to set the system authentication mode to allow multiple authenticators
simultaneously (802.1xPWA, and MAC Authentication) on a single port, or to strictly adhere to
802.1x authentication.
Syntax
set multiauth mode {multi | strict}
: dot1x, pwa, mac
: 768
: 2
: multi
: dot1x, pwa, mac
: dot1x, pwa, mac
: dot1x, pwa, mac
show multiauth
Refer to page...
20-38
20-38
20-39
20-40
20-40
Enterasys G-Series CLI Reference 20-31