Set Rmon Alarm Properties - Enterasys G3G170-24 Cli Reference Manual

Table 12-2 show rmon alarm Output Details (Continued)
Output Field
Status
Variable
Sample Type
Startup Alarm
Interval
Rising Threshold
Falling Threshold
Rising Event Index
Falling Event Index

set rmon alarm properties

Use this command to configure an RMON alarm entry, or to create a new alarm entry with an
unused alarm index number.
Syntax
set rmon alarm properties index [interval interval] [object object] [type
{absolute | delta}] [startup {rising | falling | either}] [rthresh rthresh]
[fthresh fthresh] [revent revent] [fevent fevent] [owner owner]
Parameters
index
interval interval
object object
type absolute |
delta
What It Displays...
Whether this event entry is enabled (valid) or disabled.
MIB object to be monitored.
Whether the monitoring method is an absolute or a delta sampling.
Whether alarm generated when this entry is first enabled is rising, falling, or either.
Interval in seconds at which RMON will conduct sample monitoring.
Minimum threshold for causing a rising alarm.
Maximum threshold for causing a falling alarm.
Index number of the RMON event to be triggered when the rising threshold is
crossed.
Index number of the RMON event to be triggered when the falling threshold is
crossed.
Specifies an index number for this entry. Maximum number or entries is
50. Maximum value is 65535.
(Optional) Specifies an interval (in seconds) for RMON to conduct sample
monitoring.
(Optional) Specifies a MIB object to be monitored.
Note: This parameter is not mandatory for executing the command, but
must be specified in order to enable the alarm entry configuration.
(Optional) Specifies the monitoring method as: sampling the absolute
value of the object, or the difference (delta) between object samples.
set rmon alarm properties
Enterasys G-Series CLI Reference 12-9