Area Configuration Commands; Purpose; Commands - Enterasys G3G170-24 Cli Reference Manual

Defaults
The default values are:
Metric = unspecified
Metric type = Type 2
Tag = 0
Mode
Router OSPFv3 configuration: G3(su)‐>router(Config‐router)#
Usage
The no form of this command configures the OSPFv3 protocol to prohibit redistribution of routes
from the specified source protocol/routers.
Example
This example configures route redistribution of static routes and applies a metric of 10
G3(su)->router(Config-router)# redistribute static metric 10

Area Configuration Commands

Purpose

These commands are used to configure area parameters.

Commands

For information about...
area default-cost
area nssa
area nssa default-info-originate
area nssa no-redistribute
area nssa no-summary
area nssa translator role
area nssa translator-stab-intv
area range
area stub
area stub no-summary
area virtual-link
area virtual-link dead-interval
area virtual-link hello-interval
area virtual-link retransmit-interval
area virtual-link transmit-delay
Area Configuration Commands
Refer to page...
19-10
19-10
19-11
19-12
19-12
19-13
19-14
19-14
19-15
19-16
19-16
19-17
19-18
19-18
19-19
Enterasys G-Series CLI Reference 19-9