advertise-interval
priority‐value
Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
Example
This example shows how set a VRRP priority of 200 on the VLAN 1 interface, VRID 1:
G3(su)->router(Config)#router vrrp
G3(su)->router(Config-router)#priority vlan 1 1 200
advertise-interval
Use this command to set the interval in seconds between VRRP advertisements. The no form of
this command clears the VRRP advertise interval value.
Syntax
advertise-interval vlan vlan-id vrid interval
no advertise-interval vlan vlan-id vrid interval
Parameters
vlan vlan‐id
vrid
interval
Defaults
None.
Mode
Router configuration: G3(su)‐>router(Config‐router)#
Usage
VRRP advertisements are sent by the master router to other routers participating in the VRRP
master selection process, informing them of its configured values. Once the master is selected,
then advertisements are sent every advertising interval to let other VRRP routers in this VLAN/
VRID know the router is still acting as master of the VLAN/VRID.
16-42 IPv4 Routing Protocol Configuration
Specifies the VRRP priority value to associate with the vrid. Valid values are
from 1 to 254, with the highest value setting the highest priority. Priority
value of 255 is reserved for the VRRP router that owns the IP address
associated with the virtual router. Priority 0 is reserved for signaling that
the master has stopped working and the backup router must transition to
master state.
Specifies the number of the VLAN on which to configure the VRRP
advertisement interval. This VLAN must be configured for IP routing as
described in "Pre‐Routing Configuration Tasks" on page 14‐1.
Specifies a unique Virtual Router ID (VRID) associated with the routing
interface. Valid values are from 1 to 255.
Specifies a VRRP advertisement interval to associate with the vrid. Valid
values are from 1 to 255 seconds.