Example
This example shows how to clear SNMP target parameters named "v1ExampleParams":
G3(su)->clear snmp targetparams v1ExampleParams
Configuring SNMP Target Addresses
Purpose
To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command ((page 5‐23)).
Commands
For information about...
show snmp targetaddr
set snmp targetaddr
clear snmp targetaddr
show snmp targetaddr
Use this command to display SNMP target address information.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
targetAddr
volatile | nonvolatile
| read‐only
Defaults
If targetAddr is not specified, entries for all target address names will be displayed.
If not specified, entries of all storage types will be displayed for a target address.
Mode
Switch command, read‐only.
(Optional) Displays information for a specific target address name.
(Optional) When target address is specified, displays target address
information for a specific storage type.
Configuring SNMP Target Addresses
Refer to page...
5-25
5-26
5-27
Enterasys G-Series CLI Reference 5-25