set cos port-resource
entry
name
ports
Defaults
None.
Mode
Switch command, read‐write.
Usage
The default port group 0.0 cannot be deleted.
Example
This example deletes all Port Groups except for the Default group 0.0:
G3(su)->clear cos port-config irl all
set cos port-resource
Use this command to set the inbound rate limit parameters for a specific IRL resource for a specific
port group.
Syntax
set cos port-resource irl group-type-index irl-index {[unit {kbps}] [rate rate]
[type {drop}]}
Parameters
irl
group‐type‐index
irl‐index
unit
kbps
rate rate
type drop
Defaults
None.
8-24 Policy Classification Configuration
Delete this non‐default inbound rate limiter entry.
Clear the administratively assigned textual description of this port group
entry to its default.
Clear the ports assigned to this group to its default.
Set an IRL port resource.
Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
Index number of the inbound rate limiter resource associated with this
entry. Valid values range from 0 to 99.
Unit of measure for the inbound rate limiter (only option is Kbps).
Kilobits per second.
Data rate for this inbound rate limiter. This is the actual rate limit. Valid
values range from 512 to 1,000,000 Kbps for a Gigabit port.
Action for the rate limiter. The only action option is drop the frame if all
limiters are exceeded.